Witt Sensoric GmbH Berlin - HOME

safety edges, non contact safety edge nocon, pull-in protections TwinSafe and TwinPro,
reflective photo switches RP20 and RP25, through-beam photo switch, headlight flash controller LITAS, spiral cable,
rubber profiles and accessories - Optoelectronic systems direct from the manufacturer -

optoelectronic safety edge non contact safety edge pull-in protection reflective photo switch through-beam photo switch through beam photo switch
safety control unit headlight flash controller accessories rubber profile NEWS NEWS
LITAS headlight flash controller

LITAS headlight flash controller

The LITAS system allows switching operations to be triggered by a “headlight flash”. This means it is ideally suited for opening doors for vehicles to pass through, for instance in car workshops, bus depots and train depots etc.

  • Door opening by headlight flashes
  • Intelligent processing by microprocessor controller
  • Headlight flashes adjustable from 2...5
  • Light sensitivity adjustable
  • Display by seven-segment LED module (digital display)
  • Ignores other light sources
  • Dual power supply
  • Relay output, changeover contact
  • External push-buttons can be connected
  • Up to 6 reception sensors can be connected
  • Easy to install
  • Complete installation kit

Door opening by headlight flashes:
The LITAS processing unit converts light pulses into electrical signals. When the unit has received the set number of flashes, the door opens..
Intelligent microprocessor controller:
The controller (processing unit) processes the headlight flashes. It discriminates on the basis of the number of headlight flashes, and when this matches the programmed setting it outputs an opening signal. A pulse display is available for checking the unit.
Setting the number of pulses:
DIP switches allow the number of headlight flashes for opening the door to be set from 2...5. Furthermore the sensitivity can be set (short range 2.5m, long range 6m).
Light sensitivity adjustable:
A DIP switch allows selection of the short range or long range for light reception.
Display using the seven-segment display:
The selected number of pulses is displayed. The display is counted down with each light pulse, and when zero is reached the output relay triggers. If no pulse has been received for 1.5s, the counter resets to the initial setting.
Ignores other light sources:
The intelligent LITAS processing unit is capable of distinguishing light pulses from other sources.
Dual power supply:
The LITAS 1 processing unit can be powered from a 10...40VDC or 230VAC power supply.
Relay output:
A potential-free changeover contact is provided as an output function.
External push-buttons:
Connection of external push-buttons allows an opening signal for the door to be triggered even when no vehicle is present.
Up to 6 sensors can be processed:
Several sensors, max. 6, can be connected in parallel.
Easy installation of sensors:
The neatly shaped flush-mounted sensors are encapsulated in a "snap-in" casing, which is simply pushed into the drilled hole.
Complete installation kit:
All necessary components are supplied.

ordering details
model   order number
LITAS1 Set 314945 (1.114 040)
LITEM1 single sensor 314949 (1.114 045)
Included in the scope of supply:
1 processing unit, 1 LAD1 cable junction box, 2 LITEM 1 sensors (Snap-In) 6,5m cable lenght, 1 spiral cable 3x0,5 [spiral lenght 750mm, 3m usable lenght, 200mm each end, 40mm without sheating + wire end sleeves], 1 cable gland M16, 1 cable gland M16 with anti-kink protection, 2 M16 nuts

For further technical details please refer to the following datasheet:

PDF Logo LITAS_headlight_flash_controller.pdf (1,54 MB)

PDF Logo LITAS_headlight_flash_controller_P.pdf (4,96 MB)

page up top

view this page in german this page in german